Search for: All records

Abstract During a storm, as the beach profile is impacted by increased wave forcing and rapidly changing water levels, sand berms may help mitigate erosion of the backshore. However, the mechanics of berm morphodynamics have not been fully described. In this study, 26 trials were conducted in a large wave flume to explore the response of a near‐prototype berm to scaled storm conditions. Sensors were used to quantify hydrodynamics, sheet flow dynamics, and berm evolution. Results indicate that berm overtopping and offshore sediment transport were key processes causing berm erosion. During the morphological evolution of the beach profile, two sand bars were formed offshore that attenuated subsequent wave energy. The landward extent of that energy was confined to the seaward foreshore, inhibiting inundation of the backshore. Net offshore‐directed transport was dominant when infragravity motions increased in the swash zone. Conversely, the influence of incident‐band motions on sediment transport was relatively greater in the inner‐surf zone. Near‐bed flow velocities and sheet flow layer thicknesses were larger in the swash zone than in the inner‐surf zone. This paper also provides a valuable analysis between morphology‐estimated total sediment transport rates and rates derived from in situ measurements. Sheet flow dynamics dominated foreshore cross‐shore sediment processes, constituting the largest portion of the total sediment transport load throughout the berm erosion. 

Erosion of coastal dunes during storm events is an increasingly common problem in the face of global climate change and sea-level rise. To investigate the efficacy of bio-mediated ground improvement for reducing the impact of extreme events such as hurricanes, a near-prototype-scale experiment was performed. In the experiment, a model sand dune was constructed in a large wave flume and divided into treated and untreated zones which were instrumented with pressure and moisture sensors. One of the treated sections was subjected to a surface-spray technique to apply bio-cementation. Afterward, the dune was subjected to a discretized severe storm event (a scaled Hurricane Sandy) consisting of 25 trials. Surge runup and drawdown cause surface erosion and also internal instability due to liquefaction. Pore pressure sensors were embedded in different depths of the dune to study the pressure fluctuations during the wave action and the consequent momentary liquefaction phenomenon. Momentary liquefaction leads to detachment of fine sand particles and the initiation of internal erosion and sediment transport. In this project, remote assessment technology (lidar) was used between each trial to evaluate the performance of the dune under the surge flow by detecting the eroded volume of the sand. To better quantify material properties in-situ, a series of triaxial experiments were conducted on bio-cemented cores taken from the formed crust. The strength and stiffness of the cemented sand were measured under different drainage conditions. Element test results indicate a significant increase in critical bed shear stress (τc) due to cementation. 

Coastal dunes often present the first line of defense for the built environment during extreme wave surge and storm events. In order to protect inland infrastructure, dunes must resist erosion in the face of these incidents. Microbial induced carbonate precipitation (MICP), or more commonly bio-cementation, can be used to increase the critical shear strength of sand and mitigate erosion. To evaluate the performance of bio-cemented dunes, prototypical dunes consisting of clean poorly graded sand collected from the Oregon coast were constructed within the Large Wave Flume at the O.H. Hinsdale Wave Research Laboratory at Oregon State University. The bio-cementation treatment was sprayed onto the surface of the unsaturated dune. The level of cementation was monitored using shear wave velocity measurements throughout the duration of the treatments. The treated and control dunes were subjected to 19 trials of approximately 300 waves each, with each trial increasing in water depth, wave height, and wave period. The performance of the dune was evaluated using lidar scans between each wave trial. The results indicate that the surface spraying treatment technique produced consistent levels of bio-cementation throughout the treated length of the dune and demonstrated significant resistance to erosion from the wave trails.